For Kubota D750 Water Pump 15443-73030 D850 D950 Excavator parts
Brand Name | For Kubota |
Engine Model | D750 |
Part Name | Water Pump |
Part Number | 15443-73030 |
Warranty | 12 months |
Brand | YEM |
Condition | New |
Application | Excavator |
Water pumps for Kubota D750, D850 and D950 engines, components for excavators and other equipment. Here is one description of one potential method of operation for this product:
1. Preparation: Before starting operation, make sure the vehicle or equipment is at a safe stop and the engine has cooled down. Turn off all relevant power supplies and valves to prevent accidents.
2. Locate the water pump: Locate and identify the location of the water pump according to the structure of the vehicle or equipment. Typically, the water pump is located at the front of the engine and is connected to the cooling system.
3. Relieve cooling system pressure: Locate the cooling system pressure relief valve or coolant drain valve and open it to relieve pressure within the cooling system. This will facilitate safe operation and replacement of the water pump.
4. Empty the cooling system: Empty the cooling system by draining the coolant into a suitable container. Make sure coolant is disposed of properly and comply with local environmental regulations.
5. Disassemble the old water pump: Using the appropriate tools, disassemble and remove the old water pump. This may involve removing pipes, screws, and other fasteners connected to the water pump. Make sure to record each step for reference when installing your new water pump.
6. Inspection and Cleaning: Before installing a new water pump, inspect the old water pump for any wear, cracks, or other damage. At the same time, clean the connecting parts and sealing surfaces to ensure good sealing performance.
7. Install the new water pump: Install the new water pump correctly in its location, ensuring proper alignment and securing with the correct bolts and fasteners. Tighten according to the manufacturer's recommended torque values.
8. Install other components: Install and connect the return water pipe, coolant inlet pipe and other related components, ensuring they are tight and properly connected.
9. Add coolant: Add the appropriate amount of coolant to the coolant container according to the manufacturer's recommendations and vehicle or equipment specifications, and confirm that the cooling system is filled.
10. Pressure test and inspection: After the water pump replacement is completed, release the pressure in the cooling system again to ensure that any air bubbles in the system are removed. Perform a system pressure test using a pressure gauge and check for any leaks.
Please note that as different vehicles and equipment may have specific design and operating requirements, the owner's manual or manufacturer's guide for the relevant vehicle or equipment should always be consulted during operation. The above are general operation methods, which may need to be adjusted appropriately according to the actual situation.
.
Our products are sold all over the world, you can rest assured.
