Bobcat Engine Oil Pump Replacement For S130 S150 S160 S175 Skid Steer Loader

Engine Oil Pump 3975426 6689441 For Bobcat S130 S150 S160 S175 Skid-Steer Loader

Item Include:

1 PCS Oil Pump​

Product Installation Procedure:

The Engine Oil Pump, part number 3975426 or 6689441, is designed for use in Bobcat Skid-Steer Loaders such as the S130, S150, S160, and S175 models. Here is a step-by-step guide outlining the installation procedure for this product:

Important Note: Before starting the installation process, ensure that the engine is completely cooled down, the ignition is off, and all safety precautions are followed.

1. Preparation: Gather all the necessary tools and equipment required for the installation, including a socket set, torque wrench, gasket sealant, and a new oil pump gasket (if applicable).

2. Drain the Engine Oil: Locate the engine oil drain plug and position a suitable container beneath it. Loosen the drain plug and allow the engine oil to completely drain out. Once drained, securely reinstall the drain plug.

3. Remove the Old Oil Pump: Start by disconnecting the negative terminal of the battery to prevent any accidental electrical contact. Locate the existing oil pump, usually positioned at the bottom of the engine block. Carefully remove any components, such as belts or brackets, obstructing access to the oil pump. Unbolt the oil pump from the engine block using the appropriate socket size and remove it.

4. Prepare the New Oil Pump: Before installing the new oil pump, inspect it thoroughly for any signs of damage or defects. Apply a thin layer of gasket sealant onto the mounting surface of the oil pump. If a new oil pump gasket is provided, install it according to the manufacturer's instructions.

5. Install the New Oil Pump: Align the new oil pump with the mounting holes on the engine block. Start by loosely hand-tightening the bolts before securing them with the torque wrench to the manufacturer's recommended specifications. Ensure proper alignment and clearance of any drive components, such as belts or gears, to avoid interference.

6. Reassemble Components: Reinstall any components that were removed during the disassembly process, such as belts, brackets, or covers. Ensure that all connections are secure and properly tightened.

7. Refill with Engine Oil: Using a funnel, refill the engine with the recommended quantity and grade of engine oil. Refer to the Bobcat Skid-Steer Loader's manual for specific information on the appropriate type and capacity of engine oil.

8. Check for Leaks: Once the oil pump installation is complete, start the engine and allow it to run for a few minutes. Monitor the area around the oil pump for any signs of leaks. If any leaks are detected, immediately stop the engine and address the issue before continuing operation.

Note: This installation guide provides general instructions. It is essential to consult the Bobcat Skid-Steer Loader's manual or seek assistance from a qualified technician to ensure proper installation and adherence to any specific guidelines or procedures issued by the manufacturer.

Quality Factories Show

Construction Machinery Exhibition

.

Payment and Delivery